Our shipping calculator is inaccurate. We will contact you with the correct amount and get your permission before charging your card. We apologize for any inconvenience. Call 281-842-7777 for a quote.
Key Features:
Roller Adjustment From Either End Of Carriage
Height: 28"
Adjusting Nuts 1 ¼" Hex
Rollers 4 " Dia. x ½" A 36 Steel Lathe Turned For Concentricity
Rollers Have Oilless Bronze Bushings
Roller Holders Are Made Of 11 Gauge Steel With 3/8" Basses
Adjusting Screw ¾" - 6 Pitch Full Acme Thread
Adjusting Screw Mounted In Oilless Bronze Bushings
Carriage Housing 2" x 3" 11 Gauge Tubing
Leg Pattern 23" x 26" For Working Stability
Legs Are Of "A" Frame Design
Center Braces From Middle Of Carriage To Lower Leg Brace For Even Distribution Of Load
All Legs Have 2" Dia. Foot Surface
Adjustment Of Rollers Will Accept ½" Dia. To 48" Dia. Work Piece
Roller Holders Have Drain Passages To Prevent Trapped Water When Used Outdoors
Carriage Housing Has Drain Holes To Allow Water To Drain Through Legs
Legs & Braces 1" Square Tube 16 Gauge
Rollers Are Painted With High Visibility Yellow Paint
All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor
Certified Testing By Independent Source
Working Load Capacity 6,000 LBS
Complete Stand Weight 32 LBS
Variations
108BJS - "Shortie" Adjustable Roller Pipe Jack Stand With Rubber Rollers
109BJS - Adjustable Roller Pipe jack Stand With Rubber Rollers
114BJS/WSS - Adjustable Roller Pipe Jack Stand With Stainless Steel Rollers
115BJS - Adjustable Roller Pipe Jack Stand W/Adjustable Height
Common use: Use multiple pipe jack stands to "butt weld" pipe. Any time you need to roll pipe above the ground.
Key Benefits
Legs are 1" - 16 gauge Square tubing with "A" frame design
Center Braces from center of carriage to lower leg brace for even distribution of load
Certified testing by Independent Laboratory
Rated at 6000 lb. Load Capacity (2:1 safety factor)
Adjustable to accept 1/2" to 48" diameter pipe
Adjustment nut on both ends ( Large 1-1/4" Hex Nut)
4" dia rollers with oilless bronze bushings are lathe turned for concentricity
1/2"-13 unc "T" - Handle Locks on Rollers to stop work piece from rotating when desired
Rollers are Hi Visibility Yellow
Carriage housing and roller holders have drains to prevent trapped water when left out doors
