- Roller Adjustment From Either End Of Carriage
- Height: 28"
- Adjusting Nuts 1 ¼" Hex
- Rollers 4 " Dia.Hard Rubber Rollers Have Oilless Bronze Bushings
- Roller Holders Are Made Of 11 Gauge Steel With 3/8" Basses
- Adjusting Screw ¾" - 6 Pitch Full Acme Thread
- Adjusting Screw Mounted In Oilless Bronze Bushings
- Carriage Housing 2" x 3" 11 Gauge Tubing
- Leg Pattern 23" x 26" For Working Stability
- Legs Are Of "A" Frame Design
- Center Braces From Middle Of Carriage To Lower Leg Brace For Even Distribution Of Load
|
- All Legs Have 2" Dia. Foot Surface
- Adjustment Of Rollers Will Accept ½" Dia. To 48" Dia. Work Piece
- Roller Holders Have Drain Passages To Prevent Trapped Water When Used Outdoors
- Carriage Housing Has Drain Holes To Allow Water To Drain Through Legs
- Legs & Braces 1" Square Tube 16 Gauge
- Rollers Are Painted With High Visibility Yellow Paint
- All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor
- Certified Testing By Independent Source
- Working Load Capacity 1,000 LBS because the rollers are rubber
|
